Revision 1.3

STlink header has been refactored to have the same pinout as the MMDVM_HS_Hat boards. OLED and STlink header have been exchanged. JP1 has been slightly moved. C44, C45 and C46 have been relocated nearer to the STM32F1 CPU. A table was added to the bottom silkscreen to show which TCXO is installed. This is important to the firmware. BOM and Mouser cart are still the same. The stencil has slightly changed. If you manually solder C44-C46 you can still use the old one.

Revision 1.2

An accidentially deleted 3v3 wire has been added back to the PCB layout. BOM, Mouser cart and stencil stay the same as for rev1.1.

Revision 1.1

LEDs D4 and D5 interchanged to align with scan order. Solder jumper JP1 was added. It can be closed if the board is used on Raspberry Pi only. It ties BOOT1 to GND. BOOT0 is controlled via GPIO. The 2x3 pin header can be unpopulated in this case to save space. We placed two coils on U1 and U2 for experiments with extended VCO. These are L11 and L12 and they are optional and do not need to be inserted for UHF use. Testpoints TP1 and TP2 on backside allows the demodulator output SNR to be measured with #define TEST_DAC compiled firmware.

Revision 1.0

Initial release of the PCB.