Skip to content

A tool to upload a firmware into a Sercomm router which entered download mode.

License

Notifications You must be signed in to change notification settings

danitool/sercomm-recovery

 
 

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

11 Commits
 
 
 
 
 
 
 
 

Repository files navigation

This tool allows you to flash firmware into a Sercomm router after it was put into download mode, e.g. if the original firmware was destroyed. It runs under Linux only, you must be root to execute it.

1. Compile

make

2. Enter Download Mode

  1. Power off the device
  2. Press the RESET or WPS button (this depends on the router model)
  3. Power on while holding the button
  4. Wait 5 seconds or more until the LEDs blink in a special pattern depending on the router model.

3. Run the Tool

Connect a LAN port to a NIC of the host, e.g. to eth1.

3.1. Probe the Device

./sercomm-recovery eth1

This should list some info about all device found in download mode.

3.2. Flash

./sercomm-recovery eth1 flash_burn.bin

This probes for devices in download mode. If more than one found, it prompts for the one to flash. Afterwards the firmware file is checked (matching hardware id etc.) and flashed. A reboot is executed afterwards.

4. Troubleshooting

If anything goes wrong with probing or flashing, please execute the command again with "-v", e.g:

./sercomm-recovery -v eth1 flash_burn.bin

This adds a lot of debug output to stdout.

5. Status

Currently works with:

  • Sercomm AD1018
  • Sercomm H500-s (untested)
  • Sercomm Vox 2.5 (untested)

About

A tool to upload a firmware into a Sercomm router which entered download mode.

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published

Languages

  • C 98.0%
  • Makefile 2.0%