Skip to content

csindle/ogn-hardware

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

15 Commits
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Open Glider Network Receiver Station Hardware (PipePi)

This project shows a concrete implementation of the ideas and goals on the Open Glider Network wiki page discussing how to build an OGN receiver.

Below is my current reference design which incorporates more than 12 receiver-years' worth of experience. The receivers are located outdoors, in the moderately harsh environment of the Western Cape, South Africa.

Goals:

  1. Far range: Minimise Radio Frequency (RF) path losses, and noise introduction.
  2. Affordable: Few, low-cost components, and some cheap building supplies.
  3. Simple: Largely plug-and-play components. No RF soldering, or coax-ground loops.
  4. Reliable: Standards compliant electronics, DIY casing.

The CAD files for the below diagrams are in their respective directories.

All dimensions are in millimetres.

Bill of Materials

Item Description
Raspberry Pi Version 3B, 3B+, or 4
FlightAware USB With built-in Low Noise Amplifier (LNA), but without the 1090 MHz bandpass filter
SD card 8 GB, or greater
Backplane See description below
Outdoor Enclosure See description below
PoE splitter Active, standards compliant (IEEE 802.3af)
Antenna-to-SDR adaptor Male N-type to male SMA adaptor
Antenna 868 Mhz depending on your location. Available online from China.
PoE injector Active, standards compliant (IEEE 802.3af)
Ethernet cable Rated for outdoor usage
Cable/zip-ties width less than 5 mm

Backplane

Material: ~3 mm plywood, with ~5 mm drilled holes.

The Raspberry Pi and other components are mounted upon the backplane. It provides strain relief, and durability due to its rigidity.

One may be tempted to drill only those holes that are immediately required, but in my experience, a re-configurable backplane, decoupled from the immediate components choice, is a better long-term solution. For example, the Raspberry Pi 4 upgrade swapped the USB and Ethernet positions, implying that the lower holes [only!] now need to be mirrored. A drill shouldn't be needed to swap out a RPi3 for a RPi4.

Other rigid, non-conductive material may be used instead of wood.

Wooden backplane

Weather-proof Outdoor Enclosure

Material: white, 110 mm PVC pipe, and matching commercial, off-the-shelf plumbing end-cap.

PVC pipe enclosure

Unless the end-cap is holding up the enclosure (on, say, an internal mounting), it stays on tightly enough without adhesive being required, which makes future upgrades easier.

Assembly

Raspberry Pi cable-tied to backplane and installed within the enclosure.

Parts not shown in CAD drawing:

  • PoE splitter, with 5V USB power output (RPi4 requires Type-C plug, the rest, micro-USB)
  • Ethernet cable
  • FlightAware USB RTL SDR
  • Male N-type to male SMA connector (one piece, not a pig-tail)
  • Antenna cable

Receiver's Internal Components

Assembling and securing the internal components. Receiver components

Receiver Mounted

Final installation, as high up as possible.

Thanks

To PicoJump for providing remote SSH and HTTP access, and up-time monitoring.

Please contact me, or open an issue, if you have any questions or suggestions.

About

Open Glider Network receiver station hardware

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published