This product is currently under development!
This product is a USB-HID module equipped with two tactile switches. The module is recognized as a game controller when connected to a computer with an Arduino compatible board equipped with ATmega32U4. Using the sample firmware, a press of the two tactile switches on the board is recognized as a press of game controller buttons 1 and 2, respectively.
This product is developed as a control switches for SUSTAINA-OPTM, it is used to start or stop the robot's behavior.
| Top Surface of PCB | Bottom Surface of PCB | Assembled Electronic Components |
|---|---|---|
 |
 |
- 58 mm x 22.5 mm PCB layout
- 2 x ø3.2 Mounting Holes
NKK Switches JF Series (Green: JF15SP1F, Red: JF15SP1C)
- Contact Rating: 0.05A @ 24VDC
- Circuits: Off-Mom
- Outline: 17.70mm x 17.70mm
- Operating Force: 300gf
This product is designed with the following software.
- \images
- PCB preview images and capture of design screen
- \libraries
- Libraries used in Autodesk Eagle design
- \documents
- Documentation for making and using this product
- \pcb_order
- Gerber data and documentation for ordering PCB
- \firmware
- Sample firmware to be written to the microcontroller board
- schematic.pdf
- Circuit diagram of this product
- *.brd
- Board wiring design file by Autodesk Eagle
- *.sch
- Circuit diagram design file by Autodesk Eagle
- .gitignore
- A file that tells Git not to track a particular file
- LICENSE
- License to use this product
The following documents are available for this product.
- \document\BOM.md: List of electronic components assembled on the PCB
This product was designed with reference to the following products.
If you have any questions, please contact the designer of this product, Masato Kubodera, by e-mail.
E-mail: masato.kubotera@sustaina-op.com
This product is open source. Please review the LICENSE for license information.
This product by Masato Kubotera is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.