Basic nginx configs that do not require containers or extra logging. Tested on Raspberry Pi.
Make sure host which runs this proxy has static address, for example it static in DHCP config in given network.
Example for Raspberry Pi:
sudo apt-get install -y nginx
sudo cp *.conf /etc/nginx/sites-enabled/
sudo systemctl restart nginx
Now nginx listens on ports:
8889
and points tobuddy-a.connect.prusa3d.com
- use with specific printers with PrusaConnect on firmware, such as Prusa Mini+8890
and points toconnect.prusa3d.com
- anything else such as on RaspberryPi with PrusaLink
Use command ip a
to list addresses and write down IP address under which this
host is reachable over LAN network, let say it is my-proxy-ip
.
Next, configure your Prusa printer