You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
if you keep on getting random values in your serial monitor while using the custom moisture value, then try any of this quick fix:
Attach your 10k ohm resistor to a whole different port of your microcontrller
use a 100k ohm poetentiometer by connecting any of the legs and wiper(middle leg) together and send it to a seperate ground pin of your micro-controlleer while your signal pin is connected to the third leg.
Vary the potentiometer untill u see a stable 0 (wires must be seperate with no form of conducting either directly or not)
I keep on getting random soil moisture value from the custom soil moisture sesnsor
The text was updated successfully, but these errors were encountered: