You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Is there an existing issue for this feature request?
I have searched the existing issues
Is your feature request related to a problem?
Creality Ender 3 V3 SE and V3 KE are using a CR-Touch sensor by default and create a mesh of the bed by themself.
By default, Marlin turns off using the bed mesh in the G28 command, so an additional M420 S1 command is needed at the start of the g-code, to re-enable it.
In the default profile for these printers, the M420 S1 command is missing.
Which printers will be beneficial to this feature?
Marlin
Describe the solution you'd like
After "G28; Home", a "M420 S1; Enable mesh leveling" command is needed in the default profile for these printers.
Describe alternatives you've considered
No response
Additional context
No response
The text was updated successfully, but these errors were encountered:
Is there an existing issue for this feature request?
Is your feature request related to a problem?
Creality Ender 3 V3 SE and V3 KE are using a CR-Touch sensor by default and create a mesh of the bed by themself.
By default, Marlin turns off using the bed mesh in the G28 command, so an additional M420 S1 command is needed at the start of the g-code, to re-enable it.
In the default profile for these printers, the M420 S1 command is missing.
Which printers will be beneficial to this feature?
Marlin
Describe the solution you'd like
After "G28; Home", a "M420 S1; Enable mesh leveling" command is needed in the default profile for these printers.
Describe alternatives you've considered
No response
Additional context
No response
The text was updated successfully, but these errors were encountered: